Luster

Semi-gloss

Theoretical spreading rate

Primer: 170g/m2, 10.58m2/L (calculated by 30μm dry, excluding loss)

Finishing coat:100g/m2, 13.0m2/L (calculated by 25μm dry, excluding loss)

Specific gravity:

Primer: Approximate 1.80

Finishing coat: Approximate 1.30

Drying time

Primer/ Finishing coat   :Surface dryness:1h , Solid dryness:24h

Flash point

Primer: 13℃, Finishing coat: 26℃

Storage period

Primer / Finishing coat: 12 months

Construction Instruction

Mixing ratio

Single canned

Maturing time

Open and stirring

Service life

Unlimit

Construction method

High pressure siphon spray，air spray, manual spray, roller spray

Diluent

X-21 high-temperature resistant coating diluent

Maximal dilution amount

High pressure siphon spray＜5%，air spray＜10%,  manual spray and roller spray shall not be diluted

Spray orifice

0.4~0.5mm for high-pressure siphon spray; 2.0~2.5mm for air spray

Spray pressure

12~15Mpa for high pressure siphon spray; 0.3~0.4Mpa for air spray

Tool washing

X-21 high-temperature resistant coating diluent

Film coating thickness

Primer: 90μm for wet film, 30μm for dry film

Finishing coat:70μm for wet film,25μm for dry film

Coating interval

Primer

Finishing coat

Substrate temperature

5℃

20℃

30℃

Substrate temperature

5℃

20℃

30℃

The shortest

24h

16h

8h

The shortest

48h

24h

16h

The longest

Unlimit

The longest

Unlimit

Surface treatment

*The new steel surface shall be conducted the treatment of Shot blasting or Sand blasting ,meeting the Swedish derusting standard Sa2.5 level ,roughness is40～70μm ;

*The maintaining surface can be derusted by manual machine, meeting the Swedish derusting standard Sa3 level , roughness is 40μm.

Construction condition

The substrate temperature must over 3℃ than usual ,relative humidity primer must over 50%,the finishing coat must less than 85%.

Finishing paint

Epoxy resin coatings, Epoxy asphalt coating, Chlorinated rubber coating ,Acrylic resin coating, Acrylic resin coating, Phenolic resin coating, Polyurethane coating, Chlorosulfonated polyethylene coating, High chlorinated polyethylene coating,etc.

Packing Specification

Primer:20 liters containers can load 25kg components

Finishing coat:20 liters containers can load 20kg components

Safety guide

Avoiding inhalation of vapor or mist, skin and eyes shall not be contacted with this product. In the process of construction , the forced ventilation shall be provided especially in the place which is in narrow and stagnant air condition. The protective gear shall be provided in the execution of construction.

Annotation

＊Above-said thickness of dry film and wet film refers to the index while implementing the high-pressure air-free spray;

＊Relevant data in this instruction is obtained from laboratory, the actual product may be slightly different from it;

＊If above data is changed, the data is based on the latest instruction, without prior notification.