Luster

Lusterless

Theoretical spreading rate

290g/m2, 5.00m2/L (calculated by 100μm dry film, excluding loss)

Specific gravity:

About 1.45

Drying time

23±2℃: surface dry : 2h, hard dry: 24h

Entirely cured

23±2℃: 7d.

Flash point

23℃

Storage period

12 months

Construction Instruction

Mixing ratio

Component A (paint): Component B (curing agent)=24:4

Maturing time

23±2℃: 0.5~1h

Service life

23±2℃: 8h

Construction method

High pressure siphon spray, air spray, manual brushing, roller painting.

Diluent

Diluent for X-7 epoxy coating

The largest amount of dilution

High pressure siphon spray

Air spray

Manual brushing, roller painting

5%

10%

3%

Spray orifice

0.4~0.5mm

2.0~3.0mm

_

Spray pressure

15~30Mpa

0.3~0.5 Mpa

_

Tool washing

Diluent for X-7 epoxy coating.

Film coating thickness

Wet film: 200μm, dry film:100μm

Coating interval

Grey

Maroon

Surface treatment

*Surface coated withworkshop primer need second rust removal to reach Class St3 of Swedish de-rusting standard;

*White rust, grease and other dirt on the paintwork coated with zinc-rich primer, with prolonged air exposure, shall be removed, chalked paintwork shall be polished and the dust shall be cleared away.

Construction condition

Substrate temperature shall be more than dew point above 3℃, relative humidity shall be less than 85%;

If the substrate temperature is lower than 5℃, epoxy and curing agent stop reaction, construction can’t be undertaken.

Prior primer

Zinc-rich epoxy primer, iron red epoxy Workshop primer, ethylene phosphating primer, inorganic zinc-rich primer, etc.

Finishing paint

Epoxy finish, chlorinated rubber finish, acrylic acid finish, polyurethane finish, acrylic polyurethane finish, epoxy bituminous mastic coating, etc.

Packing Specification

Container of 20 liters can load Component A of 24kg; container of 5 liters can load Component B of 4kg.

Considerations

If the maximum coating interval is exceeded, coating shall be conducted after the preceding paint surface is polished roughly to ensure the adhesion between layers.

Safety guide

Avoid inhaling solvent vapors and painting mist for long term, skin and eye may not contact with the product.

Forced ventilation shall be provided when applying the paint in confined spaces or stagnant air, although in good ventilation, protection tools shall be worn.

Annotation

＊Above-said thickness of dry film and wet film refers to the index while implementing the high-pressure siphon spray;

＊Relevant data in this instruction is obtained from laboratory, the actual product may be slightly different from it;

＊If above data is changed, the data is based on the latest instruction, without prior notification.